Tabla de contenido
Idiomas disponibles
Idiomas disponibles
and drilling ceramics and for starting to drill brick without a
piercer.
•
High speed (2) (lever forwards) (DCF10/10.8R) for
drilling brick, for drilling wood and derivatives, plastics and
metals.
The speed can be adjusted while the machine is run-ning.
However, this should not be done at full load. If, when the
machine is stopped, the selector C cannot be set in its final
position, push the on/off E switch briefly.
. Attachment of bits in the keyless drill chuck
1.
Open the drill chuck A and insert the drill bit or screwdriver
bit (in clamp H).
.
To block the bit or screwdriver tip, turn the drill chuck in
a clockwise direction, looking at the ma-chine from the front.
5. Torque adjustment
•
For use as a screwdriver, the drill-screwdriver is equipped
with an adjustable clutch, operated by the torque adjustment
control B which has 15 settings. Once it has been correctly
adjusted, the friction clutch is released when the pre-selected
torque setting is reached, to avoid the screw penetrating too
far or damage to the machine. Adjustment depends on the
type and size of the screw used. It is advisable to always
begin in the lowest setting (1) and increase gradually until the
desired result is obtained.
•
For use as a drill, set the torque adjustment control B to
the drill setting. The clutch is designed not to work in the drill
mode.
CHARGING THE BATTERY
To remove the battery F from the machine, press both side
buttons, G, situated on the handle, at the same time.
To charge the battery with a quick 5 minute charger, proceed
as follows:
1.
Place the battery charger I on a flat surface and plug the
charger into the mains.
.
Plug in the charger. the green light on
.
Put the battery in charger. If battery is in good condition,
the red light will be on. If the battery is in poor condition,the
red light will not be on. Please replace the battery.
.
The red light off when the battery is fully charged, ready
for use.
ACCESSORIES
Accessories and their corresponding order number can be
found in our catalogues.
MAINTENANCE AND CARE
Remove the battery before carrying out any opera-tion on
the machine.
-
Clean the machine very carefully after each use. The air
vents should always be kept clear.
-
Store in a dry place, away from cold .
-
Use only Felisatti accessories and spares. These should
be fitted in a Felisatti technical service centre (See Warranty/
Technical Service Centre address leaflet).
-
Brush replacement: The brushes disconnect auto-
matically and should be replaced after 80 - 100 hours use
or when they are less than mm long. Have them replaced
by an Official Service Centre. We re-commend that at every
second change of brushes, you take the machine to one of
our Official Service Centres for general cleaning and oiling.
WARRANTY
See general warranty conditions printed in separate.
5
Tabla de contenido
