i.safe MOBILE IS530.M1 Guia De Inicio Rapido página 5

FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use and removed from any ex-hazardous areas immediately. Measures
must be taken to prevent any accidental restarting of the device. The safety of the device may
be compromised, if, for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual, safety instructions and certificate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed.
To ensure the IP-protection, it has to be ensured that all gaskets are present
and functional. There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas using the i.safe PROTECTOR 2.0
or i.safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH.
The ISM interface of the IS530.M1 can be used within hazardous areas with approved
accessories. For ISM interface use, the i.safe MOBILE headset IS-HS1.1 and the SD cards type
IS-SD164.1 and IS-SD1128.1 are approved. If the ISM interface is not used, it must be securely
closed by the cover provided for this purpose.
The device may only be charged at ambient temperatures between +5°C ... +35°C.
The device may not be exposed to any aggressive acids or alkalis.
The device shall be protected against the effects of oils, greases and hydraulic fluids.
The device must be protected from impacts with high impact energy, against excessive UV
light emission and high electrostatic processes
The device may only be used in zones M1 or M2.
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails may scratch
the screen. Please maintain the screen clean. Remove dust on the screen with a soft cloth
gently, and do not scratch the screen.
Do not put the device in environments with excessive temperatures, as this could lead to
heating of the battery, resulting in fire or explosion.
Do not charge the device near any flammable or explosive substances.
Charge the device under indoor conditions only.
Do not charge the device in environments with much dust or humidity.
Do not use the device in areas where regulations or legislatives prohibit the use.
EN 5