Ryobi LCD1402 Manual De Utilización página 8

GB
FR DE ES
OPERATION
Tighten the chuck jaws securely on the bit.
Q
NOTE: Rotate the chuck body in the direction of the
arrow marked LOCK to close the chuck jaws. Do not
use a wrench to tighten or loosen the chuck jaws.
REMOVING BITS
See Figure 8.
Lock the switch trigger by placing the rotation selector
Q
in the center position.
Open the chuck jaws.
Q
NOTE: Rotate the chuck body in the direction of the
arrow marked UNLOCK to open the chuck jaws. Do
not use a wrench to tighten or loosen the chuck jaws.
Remove the drill bit.
Q
DRILLING
See Figure 10.
A level is located on the top of the motor housing to help
keep the drill bit level during use.
Check the rotation selector for the correct setting
Q
(forward or reverse).
Secure the material to be drilled in a vise or with
Q
clamps to keep it from turning as the drill bit rotates.
Hold the drill firmly and place the bit at the point to be
Q
drilled.
Depress the switch trigger to start the drill.
Q
Move the drill bit into the workpiece, applying only
Q
enough pressure to keep the bit cutting. Do not force
the drill or apply side pressure to elongate a hole. Let
the tool do the work.
WARNING
Be prepared for binding at bit breakthrough.
When these situations occur, drill has a tendency
to grab and kick opposite to the direction of
rotation and could cause loss of control when
breaking through material. If not prepared, this
loss of control can result in possible serious
injury.
When drilling hard, smooth surfaces, use a center
Q
punch to mark the desired hole location. This will
prevent the drill bit from slipping off-center as the hole
is started.
When drilling metals, use a light oil on the drill bit to
Q
keep it from overheating. The oil will prolong the life
of the bit and increase the drilling action.
If the bit jams in the workpiece or if the drill stalls,
Q
IT NL PT DK SE FI NO RU PL CZ
English
stop the tool immediately. Remove the bit from the
workpiece and determine the reason for jamming.
NOTE: This drill has an electric brake. When the
switch trigger is released, the chuck stops turning.
When the brake is functioning properly, sparks will be
visible through the vent slots on the housing. This is
normal and is the action of the brake.
WOOD DRILLING
For maximum performance, use high speed steel bits for
wood drilling.
Begin drilling at a very low speed to prevent the bit
Q
from slipping off the starting point. Increase the speed
as the drill bit bites into the material.
When drilling through holes, place a block of wood
Q
behind the workpiece to prevent ragged or splintered
edges on the back side of the hole.
When drilling large holes in wood with spade bit, the
Q
maximum drill hole size is 19mm.
METAL DRILLING
For maximum performance, use high speed steel bits for
metal or steel drilling.
Begin drilling at a very low speed to prevent the bit
Q
from slipping off the starting point.
Maintain a speed and pressure which allows cutting
Q
without overheating the bit. Applying too much
pressure will:
• Overheat the drill;
• Wear the bearings;
• Bend or burn bits; and
• Produce off-center or irregular-shaped holes.
When drilling large holes in metal, start with a small
Q
bit, then finish with a larger bit. Also, lubricate the bit
with oil to improve drilling action and increase bit life.
MAINTENANCE
WARNING:
When servicing, use only identical Ryobi
replacement parts. Use of any other parts may
create a hazard or cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
4
HU RO LV LT EE HR SI SK GR TR