Assembly; Unpack The Generator; Carton Contents; Install Wheel Kit - PowerBoss 030230 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PowerBOSS™

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag
available. See "Features and Controls" for data tag location.

Unpack the Generator

1.
Set the carton on a rigid flat surface.
2.
Remove everything from carton except generator.
3.
Open carton completely by cutting each corner from
top to bottom.
4.
Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:
• Main unit
• Engine oil
• Operator's manual
• Engine operator's manual
• Wheel kit
Figure 1 — Install Wheel Kit
5600W Portable Generator
Capscrew
Nut
Handle
Mounting Leg
If any parts are missing or damaged, call the generator
helpline at 1-800-743-4115.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 2 - 13mm wrenches
• Socket wrench with a 13mm socket
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1.
Tip generator so that engine end is up.
2.
Slide axle through both mounting brackets.
3.
Place a wheel on each side with raised hub inboard.
4.
Place a washer on axle and then place an e-ring in axle
groove.
5.
Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
Axle
Capscrew
Nut
6
ASSEMBLY
CAUTION
Wheel
Washer
E-Ring

Capítulos

Tabla de contenido
loading

Tabla de contenido