GB
Safety information
This device may be used by children
over 8 years of age, as well as persons with
physical, sensory, or mental disabilities or
inadequate experience and knowledge, if they
are under supervision or were instructed in the
safe use of the device and understand the
resulting risks. Children must not play with
the device. Cleaning and user maintenance
must not be carried out by children without
supervision.
Prevent danger resulting from damaged power
supply cables. In the case of damage, the
mains cable must be replaced by the
manufacturer or his customer service
department, or an equally qualified person.
CO
(carbon dioxide) is a gas and must not be inhaled
2
due to danger of suffocation.
Only CO
cylinders up to max. 450g may be used.
2
When using these, the floor space must be at least
2
4 m
.
The CO
cylinder is pressurised. It must only be
2
operated in the vertical position.
The use of non-genuine GROHE CO
result in damage to the pressure-reducing valve.
In the case of damaged cooling circuit:
pull mains plug. Ventilate the room in which
the device is located well for a few minutes.
Inform customer service.
Splashing coolant can lead to eye injuries.
The coolant R600a is a natural gas with high
environmental compatibility, but flammable. It
does not damage the ozone layer and does
not increase the greenhouse effect.
• Only connect the attached power cord with low-power
connection socket according to IEC 60320-C13 to a
suitable fused socket with at least a 10 A and a
ground fault circuit interrupter. The socket must be
freely accessible after installation.
Do not seal ventilation openings on the device
enclosure or on surrounding furniture.
• The system must not be transported with the CO
cylinder connected.
• The CO
cylinder must not be maintained or repaired
2
by unauthorised persons.
• During cleaning, do not spray the cooler/carbonator
or the plug directly or indirectly with water.
• The cooler/carbonator must be connected to a
permanent power supply.
All manuals and user guides at all-guides.com
• At the installation location, the cooler/carbonator,
• The cooler/carbonator must be placed in an upright
• The cooler/carbonator must not be opened.
• Installation of the fitting and cooler/carbonator with
• The cooler/carbonator is only suitable for indoor use.
• When transporting or installing the cooler/carbonator,
• For optimal cooling performance, the system will
• Do not use a damaged device.
Note:
GROHE Blue Home is not intended for commercial
areas.
The cleaning kit (Prod. no.: 40 434 001) and the
accompanying adapter (Prod. no.: 40 694 000) can
bottles can
be ordered at www.shop.grohe.com.
2
• After installing the cooler carbonator must not be
• The fitting has a system-related run-on time of
Notes on software and internet connection:
• In order to ensure the device operates with full
• GROHE takes all necessary measures to ensure safe
2
CO
cylinder and filter system must be protected
2
from mechanical damage, heat and direct sunlight.
Do not install near heat sources, other ignition
sources or open fire.
position.
filter cartridge is only permitted in frost-free rooms.
cooling fluid may have run into the lines. In order to
ensure that the cooling fluid has run back, the cooler/
carbonator may only be installed following a pause
of 24 hours.
require a rest period of 6 hours after the installation.
disconnected from the power.
approx. 1 second each time carbonated water is
drawn.
functionality, both the smartphone used and GROHE
Blue Home cooler must be connected to the internet,
and the device must have been installed successfully
via the GROHE ONDUS app beforehand. Otherwise,
the device will not be configured and no messages
can be sent.
and correct use. In the event of a malicious attack by
third parties, GROHE advises to install the latest
firmware and/or disconnect the device from the power
supply grid until you receive further information from
GROHE.
18