i.safe MOBILE IS930.2 Guia De Inicio Rapido página 5

FCC/IC STATEMENT
The FCC/IC Statement can be found under downloads on the product page of our website:
www.isafe-mobile.com/en/products.
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual, safety instructions and certificate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed.
To ensure the IP-protection, it has to be ensured that all gaskets are present
and functional. There must be no large gap between the two halves of the housing.
The device may only be charged outside ex-hazardous areas.
Physical connections to equipment are only allowed outside ex-hazardous areas using
equipment approved by i.safe MOBILE GmbH.
The device may only be charged at ambient temperatures between +5°C ... +35°C.
The device may not be exposed to any aggressive acids or alkalis.
The device may only be used in zones 2 or 22.
Only accessories approved by i.safe MOBILE GmbH may be used.
EX-RELEVANT SAFETY REGULATIONS FOR NORTH AMERICA
Conditions of Acceptability:
The battery may be charged outside explosion hazardous areas only using approved external
adapter model ICP12-050-2000B with output rated 5Vdc, 2A or other external approved AC/DC
adapter which also complies with the requirements of LPS and has output rated 5Vdc, 2A.
Physical connections to other equipment are only allowed outside ex-hazardous areas.
Opening of any interface or connector covers in explosive atmosphere is not permitted.
The product has been evaluated with rechargeable Li-ion battery pack model MBP93A01. The
battery is not considered interchangeable.
The device must be protected against excessive UV light emission and high electrostatic
processes.
The maximum rated operating temperature for charging is 35°C.
EN 5