ENGLISH
INTRODUCTION
This document contains information and safety regulations which are to be observed without
fail for safe operation of the device IS930.RG (Model M93A01) under the described condi-
tions. Non-observance of this information and instructions can have serious consequences
and/or may violate regulations.
Please read the manual and these safety instructions before using the device.
In case of contradicting information, the text of these safety instructions shall apply.
In case of any doubt, the German version shall apply.
The current EU-declaration of conformity, safety instructions and manuals can be found at
www.isafe-mobile.com or requested from i.safe MOBILE GmbH.
RESERVATION
The content of this document is presented as it currently exists. i.safe MOBILE GmbH does
not provide any explicit or tacit guarantee for the accuracy or completeness of the content of
this document, including, but not restricted to, the tacit guarantee of market suitability or fit-
ness for a specific purpose unless applicable laws or court decisions make liability mandatory.
i.safe MOBILE GmbH reserves the right to make changes to this document or to withdraw
it any time without prior notice. Changes, errors and misprints may not be used as a basis for
any claim for damages. All rights reserved.
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct or
indirect damages caused by any improper use of this device.
EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual.
FCC/IC STATEMENT
The FCC/IC Statement can be found under downloads on the product page of our website:
www.isafe-mobile.com/en/products.
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.
4