Cross Tools CPG 3000 INV Manual De Instrucciones página 32

enough fuel into the fuel filter and carburettor to fill them
completely (pump ca. 7 times) with the primer (fig. 14,
no.10) on the rear of the inverter.
5. Set the start/stop switch (fig. 16, no. 12) to "START".
6. Carefully pull the pull-cord starter (fig. 17, no. 5) until
you can feel a light resistance, then pull it more forceful-
ly.
Attention! Risk of injury!
There could be an unexpected kick-back from the
pull-cord starter, which could suddenly jam the pull-cord.
If you are starting an engine that has already warmed up,
you do not need the choke!
7. After a warm-up phase (1 - 2 min.), return the choke lever (fig. 15, no.11)
to the "Running" position. You can now connect the consumers.
5.4 Stopping the engine
1. Disconnect all connected consumers from the electrical power generator.(fig. 11)
2. Set the start/stop switch (fig. 16, no. 12) to "STOP".
3. Set the fuel cock (fig. 12, no. 8) to "Off".
Note
If you have to switch the engine off immediately due to an emergency sit-
uation, set the starter switch to "OFF" ("0").
30
Translation of the original operating instructions
The tank aeration and ventilation (fig. 13, no. 2, 3) on the
tank cover must be set to the "ON" position in order to pre-
vent a vacuum forming in the tank.
3. Before starting the engine, pump
4. Set the choke lever (fig. 15, no.11) to "start".
10