GRAPHITE 59G206 Manual Del Usuario página 21

DESCRIPTION OF USED GRAPHIC SIGNS
NOTE
WARNING
FITTING/SETTING
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Grinding wheel guard
2. Socket spanner
3. Additional handle
ATTACHING THE ADDITIONAL HANDLE
The additional handle (3) is installed in one of the holes in the grinder head. It is recommended to use the
grinder with the additional handle. When holding the grinder with both hands (also using the additional
handle), there is less risk of touching the grinder wheel or brush with your hand, as well as of injuries during
recoil.
ADJUSTABLE MAIN HANDLE
Before starting operation you can adjust the main handle to the position most comfortable for the task.
Before starting operation you can adjust the main handle to the position most comfortable for the task.
The handle can be fixed in 3 different positions by rotating it by 90º to the left or right in relation to the
base position.
• Press the main handle lock button (9).
• Rotate the main handle to a desired position.
• The main handle will automatically lock in the position.
INSTALLING AND ADJUSTING THE GRINDING WHEEL GUARD
The wheel guard protects the operator against flying broken pieces and accidental contact with a
working tool or sparks. The guard should always be fitted. Special attention should be paid so that
its covering part faces the operator.
• Install the grinding wheel guard (4) so the protrusion on its clip matches the notch on the grinder gear
casing.
• The wheel guard can be set in any position.
• Secure the mounting bolt.
The removal and adjustment of the wheel guard are performed in a reverse order to its installation.
REPLACEMENT OF WORKING TOOLS
When working tools are replaced, wear working gloves at all times.
The spindle lock button (1) is only designed to lock the grinder spindle, when a working tool is
installed or removed. Do not use it as a braking button, when the wheel rotates. Otherwise, the
grinder may become damaged or the user may be injured.
INSTALLING THE WHEELS
When grinding or cut-off wheels with the thickness below 3 mm are installed, the outer flange nut (5)
should be tightened with the flat surface from the wheel side (fig. B).
• Press the spindle lock button (1).
• Insert the special key (included) into two holes of the outer flange (5) (fig. A).
- 1 pce
- 1 pce
- 1 pce
PREPARATION FOR WORK
21