Imetec S0001 Manual De Instrucciones página 13

• Always disconnect the appliance from the mains supply before
cleaning or performing maintenance and when the appliance is not
in use.
• If the appliance is faulty or malfunctions, switch it off and do not
tamper with it. Contact an authorised technical service centre for any
repairs.
• If the supply cord is damaged it must be replaced by an authorised
technical service centre, so as to prevent all risks.
• When the appliance is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the appliance is
switched off.
• For additional protection, the installation of a residual current device
(RCD) having a rated residual operating current not exceeding 30 mA
(ideal 10 mA) is advisable in the electrical circuit supplying the bathroom.
Ask your installer for advice.
• This appliance shall not come into contact with water, other liquids,
spray, steam. For any cleaning and maintenance operation refer to the
instructions in the relevant chapter.
• DO NOT use this heater in the immediate surroundings of a bath, a
shower or a swimming pool.
• DO NOT use this appliance near a washbasin full of water. During
use the appliance must be placed in such a way that it cannot fall in
the washbasin.
• This appliance must not be located immediately below a socketoutlet.
• DO NOT leave this appliance in contact with or near materials and
surfaces that are easily flammable or can get damaged with heat.
• Use this heater on a horizontal and stable surface, or fix to the wall,
as applicable.
WARNING! In order to avoid overheating, do not cover the
heater.
WARNING! To reduce the risk of fire, keep textiles, curtains,
or any other flammable material at a minimum distance of 1
m from the air outlet.
EN
11