Idiomas disponibles
Idiomas disponibles
To cut an angle:
1. Adjust angle guide to desired angle and place the
guide against the tile.
3. Flip the breaker down and position slightly away
from the front edge of the tile.
1. Adjust the Hex Bolts & Nuts on the Sliding Block as desired to modify sliding pressure. Ensure both the left
and right sides are adjusted equally.
2. Before storage, lubricate the rail on the cutter with a few drops of light oil to prevent rust.
3. Replace the scoring wheel when cutting becomes difficult or the score line is not clean. This is a standard
wear part.
REF #
32484
32485
32486
32487
EXTENSION ARM WITH BRACKETS & FASTENERS - TC36
WS2770
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
REPLACEMENT PARTS
DESCRIPTION
SCORING WHEEL WITH FASTENERS - TC36
GUIDE FENCE WITH THUMBSCREW - TC36
BREAKER FOOT WITH FASTENERS - TC36
2. Carefully lower wheel until it makes contact with
tile and then apply consistent pressure while
scoring full length of the tile.
4. Apply increasing downward pressure on handle
until the tile snaps.
NOTES
PART#
Quantity
TC36SW
1
TC36GF
1
TC36BF
1
TC36EA
2
5 of 6
