Lay the black antenna wire on top of the receiver (E) and
then place the receiver (E) into the hanger bracket (A)
above the ball portion of the downrod (B).
Make sure the tab on the hanger bracket
(A) properly sits in the groove in the hanger ball (B) before
attaching the canopy (B) to the hanger bracket (A) by turning
the motor housing (B) until it drops into place.
Tuck connections neatly into the ceiling outlet box.
Loosen the canopy mounting screws (II) on the hanger
bracket (A).
Slide the canopy (B) up to the hanger bracket (A) and
place the key hole on the canopy (B) over the loose canopy
mounting screw (II) on the hanger bracket (A). Turn the
canopy (B) clockwise until the canopy (B) locks in place at
the narrow section of the key holes and tighten the canopy
mounting screws (II).
E
B
II
A
II
B
