Kohler 23467 Guia De Instalacion

Installation Guide
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box
before beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
TOOLS AND MATERIALS NEEDED
Phillips &
Flathead
Screwdriver
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto
a clean and soft cloth to protect finish. Confirm all parts are
included.
2. Attach mounting plate (B) onto outlet box with screws (C).
3. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture green or bare ground wire to the green or bare
copper wire in outlet box with wire nut (A) or fasten onto ground
screw (M) on mounting plate.
4. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture white wire to the white wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A), see diagram.
5. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten the fixture black wire to the black wire in outlet box with
wire nut (A). Wrap the wire connector with electrical tape so that
the tape seals the end of wire nut (A), see diagram.
6. Press together the two connectors (D).
7. Tuck wires carefully inside outlet box. Attach the canopy (F) onto
mounting plate (B) by securing screws (E).
8. NOTICE: Product will operate with or without liquid. Pour liquid into
the glass (K), 90% full is recommended. For recommended liquids
visit www.kohler.com.
9. Seal the glass (K) by securing rubber ring (J) and cap (I) firmly. Next
install glass (H) onto glass holder (G) by turning until the
connection is tight and be careful not to over-tighten.
TO AVOID SHORT CIRCUIT AND RISK OF ELECTRIC SHOCK, DO NOT
FILL GLASS BALL NEAR ELECTRIC SOCKET OR ELECTRICAL
JUNCTION POINT.
10. Restore power to circuit at breaker or fuse box.
WARNING: For dimming of this fixture, only compatible dimming devices as outlined on the spec sheet are allowed. Visit
www.kohler.com to view the spec sheet.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
USA/Canada: 1-800-4 KOHLER
www.kohler.com
Please see next page for a larger installation image
Small
Slip Joint Adjustable
Pliers Wrench
Electrical
Wire Current
Cutter/stripper Tester
Electrical tape
Approved fastener
(Wire nut)
SKU#23467
Electrical
Tape
1408416_2