Memory Function; Cleaning And Storage - Beurer EM 28 Instrucciones De Uso

Preventing unwanted pulse changes
To prevent unintentional increases in intensity during a treat-
ment, simply switch the button lock on. To do this, press and
hold the program selection button P [3] for approx. 2 sec-
onds. An acoustic signal sounds and the symbol "
appears in the display [6]. To release the button lock, press
and hold the P button [3] for approx. 2 seconds.
Reacting to unpleasant sensations
If you feel a twinge or itching on your skin, you should switch
the device off and proceed as follows:
• Check that the electrodes are OK and do not show any
signs of damage.
• Check that the round cover is still on the electrode connec-
tions.
• Remove the cuff and moisten it again completely.
• When you put it back on, ensure that there is good contact
with the skin and that the skin is damp.
Pausing a program
If you want to pause a program while it is running, press the
Pause button [1]. An acoustic signal sounds and the pause
symbol "II" flashes in the display [6]. The program can be
continued by pressing the button [1] again.
Contact detection
If the electrodes are not in contact with the body, the inten-
sity will automatically be set to zero. This prevents unwanted
electrical stimulation. The intensity cannot be increased if
the electrodes are not in contact with the body.

Memory function

The device saves the last program that was set.
After replacing the battery, the device starts again with the
first program.
"

7. Cleaning and storage

Cleaning the control unit
Important
Before beginning the cleaning process, disconnect the
connection cable from the control unit and the cuff and
remove the batteries.
Clean the control unit after use with a soft, slightly damp
cloth. If it is very dirty, you can also moisten the cloth with
a mild soapy solution. Do not use any chemical or abrasive
cleaning agents. Ensure that no water gets inside the control
unit.
Cleaning the wrist cuff
Important
1. Before beginning the cleaning process, disconnect the
connection cable from the cuff.
2. C lean the cuff carefully in lukewarm, soapy water. Do not
use hot water. Afterwards, rinse it thoroughly with water
so that no soap remains on the cuff.
3. Then carefully pat the cuff dry with a towel and leave it
to dry.
27