Black and Decker GS1600 Manual De Instrucciones página 11

The earth wire should be of a length to ensure
that in the event of the cable being pulled
from the plug, the earth wire is the last to
break contact.
Before replacing the top cover of the mains
plug ensure that the cable restraint (3)
is holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
If the plug has a fuse cover, make sure that the
fuse cover is fitted. Do not use the plug if the
fuse cover is missing or damaged.
Never use a light socket.
Using an extension cable
Always use an approved 3-core extension cable
suitable for the power input of this tool
(see technical data). The extension cable must be
suitable for outdoor use and marked accordingly.
When using a cable reel, always unwind the cable
completely.
CARTON CONTENTS
The carton contains:
1 Shredder body with chute
4 Legs
4 Leg retaining screws
1 Allen key
1 Spanner
1 Funnel
1 Prodder
1 Crossbar
2 Sleeves
2 Bolts
2 Nuts
2 Washers
2 Wheels
1 Instruction manual
Carefully unpack all parts.
OVERVIEW (fig. A)
1. On/off switch
2. Body
3. Chute
4. Rear leg assembly
5. Front legs
6. Leg retaining screws
7. Thumb nut
8. Funnel
ASSEMBLY
Before assembly, make sure that the tool
is switched off and unplugged.
Fitting the legs (fig. B, D1 & D2)
Loosen the thumb nut (7) and remove the
chute (3) (fig. D1 & D2).
Turn the shredder upside down and place it on
the floor.
Insert the rear legs (4) into the corresponding
openings in the body (2) as shown (fig. B).
Align the screw hole (19) with the bottom of
the slot (20).
Secure each of the legs with a retaining screw (6).
Mount the wheels (16) and crossbar (17) onto
the legs, using the sleeves (13), bolts (14),
nuts (15) and washers (18) as shown.
Insert the front legs (5) into the corresponding
openings in the body (2) as shown. Align the
screw hole (19) with the bottom of the slot (20).
Secure each of the legs with a retaining screw (6).
Turn the shredder into the upright position and
refit the chute. Securely tighten the thumb nut.
Fitting the funnel (fig. D2)
Align the funnel (8) with the chute as shown.
Press the funnel down onto the chute (3) until it
snaps into place.
USE
Let the tool work at its own pace.
Do not overload.
Before starting the tool ensure that the
feed intake is empty.
Do not switch the shredder off before it
is completely empty, as it may clog and
be difficult to restart.
Remove soil and stones from plant
roots before shredding.
Firmly hold branches when feeding
them into the shredder.
E N G L I S H
11