Attaching Handle - Uline JUMBO H-1871 Manual Del Usuario

Figure 8

ATTACHING HANDLE

1. Place the locking door handle (12) on the right
hand door and fasten with two slotted bolts and
lock washers. (See Figure 8)
2. Turn the handle to the open position (See Figure 9)
and place the locking cam (16) over the square
shank of the door handle. Place the cotter pin (13)
through the hole of the square shank.
(See Figure 10)
3. With the handle still in the open position, hook the
lock bars (15) into the locking cam (16). Once in
position, slowly rotate the door handle to the closed
position so the lock bars protrude from the holes at
the top and bottom of the door. (See Figure 11)
4. Slide the nylon lock bar guides (14) over the lock
bar (15) ends and through the door slots. Push firmly
until the guides snap into place. If necessary, turn
the handle back to the open position and gently
tap with a hammer until the guides snap into place.
(See Figure 12)
5. Attach dummy handle (12) to the left door using two
slotted bolts and lock washers.
Open Position Open Position
Figure 9
PAGE 5 OF 15
ASSEMBLY CONTINUED
12
Closed Position Closed Position
1-800-295-5510
uline.com
Figure 10
Figure 11
15
15
16
16
15
15
13
16
Figure 12
14
14
0221 IH-1871
14
14