Remedy Of Faults; Maintenance And Cleaning - Oase ProfiLux LED 110/DMX/02 Instrucciones De Uso

- GB -

Remedy of faults

Malfunction
No spotlight is lit.
One spotlight is not lit.
An individual spotlight does not light up in the
desired colour.
Luminous intensity of a spotlight is insufficient.
Repair
The unit can only be repaired by OASE. Please send the unit to your OASE dealer.

Maintenance and cleaning

Cleaning the unit
• Clean all components with clean water and a soft brush.
• Never clean the device using a pressure washer.
Unit maintenance
The unit requires regular maintenance. Carry out the work according to the maintenance schedule.
• Only allow the maintenance work to be carried out by trained personnel who are qualified for these activities due to
their technical training, knowledge and experience.
Storage/Over-wintering
Observe the permissible operating temperature range. (→ Technical data)
• If the limit values are exceeded or gone below, it is necessary to remove the unit. Clean the unit thoroughly and
check it for damage.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
18
37744_04-14_GA_ProfiLED_110_320_18 18
Cause
No supply voltage
The luminous intensity of all spotlight LEDs is
0 %.
Underwater LED driver, DMX controller or swit-
ching power pack defective
Spotlight not connected.
The luminous intensity of all spotlight LEDs is
0 %.
Spotlight or underwater LED driver output de-
fective
Underwater LED Driver /DMX/02 is not compa-
tible with the spotlight.
Incorrect spotlight setting
LED of the spotlight defective
Spotlight LEDs excessively dimmed
The luminous intensity has been automatically
reduced due to excessive temperature in the
spotlight.
Spotlight glass soiled
Remedy
Check all cables and connections.
− Change the spotlight setting.
− Check the luminous intensity of the LEDs
and the DMX address.
Determine which unit is defective and proceed
with the malfunction remedy according to its in-
struction manual.
Check connection between spotlight and LED
driver.
− Change the spotlight setting.
− Check the luminous intensity of the LEDs
and the DMX address.
− Connect the spotlight to a different output on
the underwater LED driver.
− Have spotlight repaired.
− Have underwater LED driver repaired.
Use underwater LED driver /DMX/02, ver-
sion 2.0. The following spotlights are only com-
patible with version 2.0:
− ProfiLux LED 110/DMX/02 (56267)
− ProfiPlane LED 110/DMX/02 (56298)
− ProfiLux LED Spot 1500/DMX/02 (56388)
− ProfiLux LED Flood 1500/DMX/02 (56391)
− Change the spotlight setting.
− Check the values for the LEDs, DMX add-
ress and configuration mode.
Have spotlight repaired.
− Change the spotlight setting.
− Check the values for the LEDs, DMX add-
ress and configuration mode.
No measure required.
Clean spotlight glass.
11.04.2014 11:53:46