Kenmore A03355201A Instrucciones De Instalación página 6

Installation Requirements
Drain system requirements
1 Drain capable of eliminating 17 gals (64.3 L) per
minute.
2 A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
3 The standpipe height above the fl oor should be:
Minimum height: 33 in. (84 cm)
Maximum height: 96 in. (244 cm)
NOTE
For installations requiring a longer drain hose, have
a qualifi ed technician install hose P/N 134592700,
available from Sears Parts & Repair. Call 1-800-4-MY-
HOME. For drain systems in the fl oor, install a syphon
break kit available from Sears Parts & Repair.
Exhaust system requirements
Use only 4 inch (102 mm) diameter rigid or fl exible metal duct and approved
vent hood which has a swing-out damper(s) that open when the dryer is in
operation. When the dryer stops, the dampers automatically close to prevent
drafts and the entrance of insects and rodents. To avoid restricting the outlet,
maintain a minimum of 12 inches (30.5 cm) clearance between the vent hood
and the ground or any other obstruction.
WARNING
Failure to follow these instructions can create excessive drying times and fi re
hazards.
The following are specifi c requirements for proper and
safe operation of your laundry center.
WARNING
Do not install a clothes dryer with fl exible plastic or metal foil venting
materials. Flexible venting materials are known to collapse, be easily crushed
and trap lint. These conditions will obstruct clothes dryer airfl ow and increase
the risk of fi re.
If your present system is made up of plastic duct or metal foil duct, replace it
with a rigid or semi-rigid metal duct. Also, ensure the present duct is free of any
lint prior to installing dryer duct.
FIRE HAZARD
FIRE HAZARD
96"
(244cm)
max.
33"
(84cm)
min.
6
Correct
Incorrect