Kenmore A03355201A Instrucciones De Instalación página 15

Electrical connection (non-Canada) - 3 wire cord
3-wire receptacle
(NEMA type 10-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
1 Turn off power supply to outlet.
2 Remove the screw securing the terminal block access
cover in the lower corner on the back of the dryer.
3 Install a UL-approved strain relief according to the
power cord/strain relief manufacturer's instructions
in the power cord entry hole below the access panel.
At this time, the strain relief should be loosely in
place.
4 Thread an UNPLUGGED, UL-approved, 30 amp.
power cord, NEMA 10-30 type SRDT, through the
strain relief.
5 Attach the power cord neutral (center wire)
conductor to the SILVER colored center terminal on
the terminal block. Tighten the screw securely.
6 Attach the remaining two power cord outer
conductors to the outer, BRASS colored terminals on
the terminal block. Tighten both screws securely.
WARNING
ELECTRICAL SHOCK HAZARD
• Do not make a sharp bend or crimp wiring/conductor
at connections.
• DO NOT remove the internal ground from the GREEN
screw next to the terminal block.
7 Follow manufacturer's guidelines for fi rmly securing
the strain relief and power cord.
8 Reinstall the terminal block cover.
IMPORTANT
If moving dryer from a 4-wire system and installing it
in a 3-wire system, move the internal ground from the
center terminal back to the GREEN screw next to the
terminal block.
Installation Instructions
30 AMP 30 AMP
NEMA 10-30 NEMA 10-30
DO NOT remove
internal ground in a
3-wire system!
15
Neutral Neutral
(center wire) (center wire)
Neutral
terminal