Tabla de contenido
Belt
Courroie
Correa
Motor Shaft
Arbre du moteur
Eje del motor
Carpet/Bare
Floor Selector
Shaft
Arbre d'entraînement
du sélecteur
tapis/plancher
Selector alfombra-piso
Motor Shaft
Arbre d'entrainement
du moteur
Belt
Eje del motor
Courroie
Correa
2
Four Screws
Quatre vis
Cuatro Tornillos
Agitator
Agitateur
Agitador
End Cap
Bouchon
Tapa del
extremo
Groove
Rainure
Ranura
Tabs
Languettes
Lengüetas
1
Slots
Fentes
Ranuras
- 46 -
➢ Loop new belt (part number
MC-V390B, Type UB12) around
Carpet/Bare Floor selector shaft and
agitator belt groove. Make sure belt
is routed in the belt guide as
shown. See illustration for correct
belt routing.
➢ Reinstall agitator back into nozzle
by placing end caps into grooves.
➢ After reinstalling the agitator, turn it
by hand to make sure that belt is
not twisted or pinched and that all
rotating parts turn freely.
➢ Place the vacuum cleaner in the
upright position standing on the
handle. This will minimize wheel
interference when installing lower
plate.
➢ Reinstall lower plate by (1) aligning
tabs on front edge of lower plate
with slots in the nozzle and (2)
rotating to installed position.
➢ Lay vacuum cleaner on the floor
with the bottom up and nozzle flat.
➢ Install the four screws to the nozzle
cover.
➢ Route nozzle hose to hose holder.
Align nozzle hose bracket with
retaining bracket on body and slide
down unit it clicks into place.
➢ Return the vacuum cleaner to the
upright position before plugging
into an electrical outlet.
Tabla de contenido
