Tabla de contenido
Idiomas disponibles
Idiomas disponibles
user's instructions
technicAl inforMAtion
Type:
AST8000
Power:
1200 W for the iron
1400 W for the boiler
2600 W maximum total
Power supply:
220-240 V ~50 Hz
operAtion
- General
The appliance is intended only for domestic use,
not for professional use.
6
8
7
1. Electricity and steam cable
2. Iron temperature control
3. Steam release button
4. Iron
5. Sole plate
6. Heat resistant non slip tray for the iron
7. Removable water tank
before first use
Before using the iron for the first time, begin by ironing a piece of old fabric to ensure that the soleplate and
water reservoir are clean. Repeat this when the iron has not been used for a period of time. The appliance
may emit a little smoke and a characteristic smell when you switch it on for the first time. This is normal,
and will soon stop. Make sure the appliance has sufficient ventilation
use -
fillig the water reservoir
1. The appliance can be filled with water before and during use. You can do that by opening the water
tank lid (8) and using the supplied measuring cup. You can also take out the water tank (7), fill under
the tap and then reinstall it.
2. Fill the water tank with a maximum of 0.8 litres of clean tap water.
Never fill by holding the complete appliance under a running tap. There is a good chance that water
will flow over the casing and into the appliance.
If you live in an area with hard water, it is recommended to use distilled or demineralized water.
Never add a stain remover or other additives to the water.
Leave the device steaming ( for ca. 20 sec) before every use by pushing the steam release button (3)
to remove calcium deposits.
2
4
3
5
1
9
10
8. Water tank lid
9. Pilot light (iron warming up)
10. Pilot light (building up pressure)
11. Main on/off switch with pilot light
12. Boiler temperature control
13. Power cord and plug
19
11
12
13
Figure 1
Tabla de contenido
