Attaching Saw Without Quick Mount System™ To Saw Mounting Brackets And Stand - Skil 3302 Instrucciones De Funcionamiento Y Seguridad

SM 2610028634 12-12_SM 2610028634 12-12.qxp 12/20/13 10:50 AM Page 8
Attaching saw without Quick Mount System™ to saw
PREPARING SAw MOUNTING BRACKETS
See Figure 6.
1. Place a sliding mounting plate (1) onto each of four
5/16 in. x 2 in. carriage bolts (2) and feed bolts into
both mounting brackets (3) as shown in figure 6.
2. Thread one bracket locking knob (7) into the end of
each extension rail (3) as shown.
ATTACHING SAw wITHOUT QUICK MOUNT
SYSTEM™ TO SAw MOUNTING BRACKETS
Turn
W RNING
disconnect power before mounting
to the stand. Unintended startup during assembly can
cause injury.
See Figure 7.
Always position the saw to achieve maximum balance
and stability. All four corners of the saw must be bolted
to the mounting brackets before use. Make sure bolts
do not extend above the table of the miter saw.
If the saw has four holes that line up with the slots
in the saw mounting brackets:
1. Unplug the saw and lock the saw arm in the down
position.
2. Lift one side of the saw and place a saw mounting
bracket underneath, aligning the carriage bolts with
the miter saw mounting holes, as shown in figure 7.
3. Lower the saw down onto the bracket, feeding the
carriage bolts through the mounting holes.
4. Secure in place using a flat washer (4), lock washer
(5), and nut (6).
5. Repeat steps 1 through 4 to install second bracket
to the other side of the saw.
6. After making sure both brackets are parallel to each
other, finger tighten all four nuts to hold in position.
mounting brackets and stand
tool switch off and
3
1
2
FIG. 7
6
5
4
8
FIG. 6
7