Adjustments - Skil 3302 Instrucciones De Funcionamiento Y Seguridad

SM 2610028634 12-12_SM 2610028634 12-12.qxp 12/20/13 10:50 AM Page 10
BRACKET ADJUSTMENT SCREw
See Figure 10.
Mounting brackets are designed to fit snugly over the
stand rails. With the locking knobs are tightened to
their locked position, you should not be able to remove
the saw and bracket assembly from the rails. If the
saw and bracket assembly can be removed from the
rails when locked, the bracket adjustment screws need
to be tightened. If the saw and bracket assembly will
not fit over both rails, the bracket adjustment screws
needs to be loosened.
NOTE: The saw should be removed from the
mounting brackets before attempting to tighten or
loosen the bracket adjustment screws.
To adjust:
1. Use a wrench (1) to slightly loosen the nut (2).
2. Turn the screw (3) with a phillips screwdriver (4).
Rotate clockwise if the bracket assembly needs to
be tightened or counterclockwise if the assembly
needs to be loosened.
3. Install the bracket on the miter stand rails and
tighten the bracket locking knob to check the
adjustment.
4. When the correct position is achieved, wrench
tighten the nut to secure.
5. Repeat with the second mounting bracket.
See Figure 11.
The stand is equipped with an adjustable foot for
leveling the stand.
To adjust: loosen wing nut (1) and adjust the height of
the foot (2) by screwing the threaded shaft clockwise
to raise foot or counter-clockwise to lower foot.
Retighten wing nut securely.
To reduce the risk of injury, ensure
W RNING
the stand is stable and level before
operating the saw. Choose a level area to set-up the
stand and adjust the adjustable foot so that all four
legs are touching the ground.
With the saw mounted on the stand:
1. Lower the miter saw head to the full cut position and
release the miter saw head uncontrolled from the full
cut position. The saw and stand shall not tip over.
2. Check for fit and function. There shall be no

Adjustments

TO LEvEL STAND
STAND COMPATABILITY TEST
2
3
FIG. 11
interference of miter saw throughout the full range of
miter, bevel and compound cut.
3. The work support shall be able to adjust to a height
that is level with the table top of the miter saw."
10
1
4
FIG. 10
1
2