Astralpool NanoFiber 64837 Manual De Instalación Y Mantenimiento página 5

When starting up for the first time, read the pressure of the pressure gauge. It
is recommended to take note of this pressure, as later it will be used to know
whether the filter is dirty and if "WASHING" is required. "WASHING" should
be done when the pressure gauge indicates an increase of 0.5 kg/cm
pect to the initial pressure of the filter. it is advisable to observe the pressure
gauge from time to time as this indicates the degree of saturation of the filter
Bear in mind that the valves at the bottom of the pool and the skimmers will
be adjusted according to the amount of floating particles on the surface of the
water. The main drain and skimmer valves will be regulated according to the
quantity of floating material found on the surface of the water. Bear in mind
that with the main drain valve fully open there will be little suction from the
skimmers. If the surface sweep of the skimmers is to be stronger, reduce the
flow from the main drain.
Example:
0,8 kg/cm : Initial pressure of the filter at
²
the start of a filtering cycle.
Note: the initial operating point will depend on the design of the installation and the flow rate used.
BACKWASH:
When the pressure has reached 0.5 kg/cm
cannot take in any more dirt and must be backwashed in the following way:
The multiport valve should be set to the Backwash position.
Open the sump
non-return valves,
switch the pump on. Turn
slowly the orange
at the top in every direction
for 2 minutes. Following
this operation, all of the
dirt obstructing the
tridge will have been pou-
red into the drainage pipe.
RECIRCULATE:
In this position, the selector valve allows the water from the pump to go di-
rectly to the swimming pool without passing through the inside of the filter.
above the initial pressure setting, this means that the cartridge
²
and
and
lever
car-
with res-
2
1,3 kg/cm²: The pressure is 0.5 kg/cm
more than the initial pressure, indicating
that WASHING is required.
5
2