Troubleshooting - Noaton AC 5109 Manual De Uso

T
ROUBLESHOOTING
BEFORE CONTACTING TECHNICAL SUPPORT
PROBLEM
Appliance does not start
Power on/off button does
not work
The unit has switched itself
on, but the compressor is
not working
Remote control does not
function
Increased noise level
Too loud in the bedroom
Cannot change fan speed-
Cooling is not effective
Appliance switches itself
off.
Water leaked when moving
the machine
,
PLEASE CHECK THE FOLLOWING TABLE
POSSIBLE CAUSE
Appliance has no power supply
Appliance is not switched on
Follow the instructions above.
Wait for a while
Worn out battery/remote control
out of range
Dirty air filter
Air intake is blocked
Uneven floor
Cool the room in advance
Appliance is in dehumidification or
sleep mode.
Room is too big
Too much direct sunlight
Machine has not been running for
a long enough time
Air filter is dirty or blocked
Required temperature has been
reached
Internal water tank is full
45
.
SOLUTION
Plug the appliance into the mains.
Press the on/off button (POWER).
If the problem cannot be solved,
contact the manufacturer.
The compressor will come on after
the first three minutes of
operation. This technical measure
extends the appliance's lifespan.
Change the battery in the remote
control or stand nearer the
appliance.
Clean the air intake filter.
Check to see whether furniture or
curtains are blocking the air intake.
Place the air conditioner unit on a
level surface
Start the air conditioner several
hours before you go to bed, and
make sure curtains and doors are
shut so that the room is cool before
sleep.
Change the appliance mode, if
required (MODE button).
Check whether cool air is coming
out of the machine and either let
the machine run for a longer time,
or relocate it into a smaller room.
Keep doors and windows shut.
Prevent direct sunlight by using
blinds or curtains.
Cooling the room will take longer if
a large amount of heat has
accumulated in the walls and other
parts of the room. Let the machine
run for a longer time.
Clean the filter.
If you would like the machine to
continue running, set a lower target
temperature.
Always drain the water tank before
moving the unit.