Control Panel; Power On/Off Button (Power); Mode Change Button (Mode); Timer Button (Timer) - Noaton AC 5109 Manual De Uso

Control panel

Power on/off button (POWER)

Once connected to the mains power supply, the air conditioner will enter standby mode, the display will flash
for a time and emit an audio signal. Press the on/off button (POWER) and the unit will switch to the initial
"Smart" mode. To protect the compressor, when the appliance is switched back on it will not start for a period
of three minutes.
By pressing the on/off button once again you will switch off the appliance; the fan will continue to function for
an additional 10 seconds or so after the machine has been switched off.

Mode change button (MODE)

Press the MODE button to change available modes - COOL/SMART/FAN.

Timer button (TIMER)

+ -
If the air conditioner is in standby mode, using the timer button and the " " and " " buttons you can set an
interval between 1 and 24 hours after which the appliance will switch itself on. The appliance display will show
the remaining time until it starts up in hours [Note: always rounded up to the nearest whole hour; so, if e.g.
there is 1 h and 15 min until the start, the display will show 02].
In this mode it is also possible to set the required setting after the appliance has started, either by using the
buttons on the display or with the remote control.
If the air conditioner is switched on an running, you can use the timer button to set an interval between 1 and
24 hours after which the appliance will switch itself off.
By selecting 0 hours the timer function will switch itself off.
39