Troubleshooting - Alliance International IPSO RI1600/30 Manual De Uso & Mantenimiento

TROUBLE
Upon switching on the ironer does
not work.
The roller does not turn and the
ironing plate does not drop.
After adjusting the temperature by
means of the thermostat,
ironing plate does not heat.
N.B.: All checks and any technical work must be carried out by fully competent, qualified personnel.

TROUBLESHOOTING

POSSIBLE CAUSE
Mains power failure.
M a g n e t o t h e r m a l
intervention.
Card protection fuse (F4) blown.
Inverter fuse (F1) blown.
Inverter protection activated.
Emergency devices
(display shows "Err".)
Safety thermostat activated.
the
Thermostat probe
display shows "Er1" for the right,
"Er3" for the left.
Thermostat probe in short circuit:
display shows "Er2" for the right,
"Er4" for the left.
Measured temperature difference
between right
higher than 40°C.
Check if supply terminals are live.
s w i t c h Check dispersion toward earth.
Replace fuse and check for cause.
Replace fuse and check for cause.
Check error message on inverter
display.
activated Disactivate the emergency device
and press the pedal.
Reset the safety thermostat using
the relative push button.
disconnected: Check probes connection.
Use properly the whole ironing
and left probes surface.
REMEDY
16/41