Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Remove the cutting disc
(1) Remove the safety cover from the motor. Locate the 24mm wrench (7) inside the end of the coil (1)
Secure the coil by hand. Untie the screw and washer with the 24mm wrench with your other hand. (5)
(2) Untie screw and washer (6), Washer (A) washer wheel (4) one by one, then remove the
cutting disc (3)
2. Installation of Disc (pulley) cut Clean screws and disassembled washers from dust. To install them, check
the procedure mentioned above, but in reverse.
After replacing the cutting disc, verify that the bar has been properly reinstalled from
the washer wheel; since you must turn the cutting disc counterclockwise. When the engine is started
without the bar being released it could become tied and damaged.
2. Changevice angle
Vice angle can be changed up to 45 degrees. Loosen the two screws on the bracket (B), then position it in
the desired position at any angle of the support (B) as shown in figure (B). Then tighten the two screws
firmly.
Change the steering angle to (A) if possible. This sense can result in greater security for the fastener and
faster than (B).
8
www.ELITETOOLS.co
Keep Working
Tabla de contenido
