Cutting Disc Replacement - Elite CS1425 Manual De Usuario

CUTTING DISC REPLACEMENT

1. Replace the cutting disc
Disconnect the plug from the power source before replacing the cutting disc to prevent possible accidents
(machine cuts).
(1) Lower the bar (1) with your left hand to insert the washer wheel (2) into the slot. Look at it and then
loosen the screw with the wrench (5).
(2) Untie screw and washer (4) and washer wheel (3) one by one, then remove cutting disc (6).
2. Install the Cutting Disc
(1) Clean the disassembled screws and washers from the dust. To install them, check the procedure men-
tioned above, but in reverse (4).
(2) After tying the screw and the washer, check to see the bar (1) that it has been reassembled and properly.
1
Llave
1
2
6
2
3
4
4
5
3
www.ELITETOOLS.co
5
7
6
Llave
Keep Working