Braun CareStyle 3 Manual Del Usuario página 12

Trouble shooting guide
PROBLEM
Steam comes out under the
base unit.
There are some water drops
from the holes in the bottom
of the soleplate.
Brown coloured fluid leaks
from the soleplate.
The first time the appliance is
turned on, you notice smoke /
smell.
The appliance emits an
intermittent noise associated
with vibrations.
The cleaning valve is difficult
to unscrew.
All LEDs are flashing.
Steam comes out from the
cleaning valve.
Ironing system is ready, but
no steam emission from the
iron.
Subject to change without notice.
Please do not dispose the product in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection points
provided in your country
DLB239760-01_5712811751_CaresStyle_3_IS3022_INT_UI.indb 11
CAUSE
The "max" pressure safety system
has opened.
Water has condensed inside the
tubes because steam is being used
for the first time, or has not been
used for some time.
The temperature selector is not in the
correct position.
Chemical water softeners, distilled
water or additives have been poured
into the water tank or boiler.
Some parts have been treated with
sealer/lubricant which evaporates the
first time the iron heats up.
Water is being pumped into the boiler. This is normal and no action is needed.
The water tank is empty.
Lime scale has made the cleaning
valve difficult to open.
System error.
The cleaning valve is not tightened
correctly.
The cleaning valve gasket is
damaged.
End of water alarm has been reset
without water refill.
REMEDY
Turn the appliance off immediately and contact an
authorised Braun Customer Service.
Press the steam button several times away from the
ironing board. This will eliminate cold water from the
steam circuit.
Set the temperature between temperature level 2
(••) and "max" on the temperature selector.
Never pour products into the water tank. Clean the
sole plate with a damp cloth and rinse the boiler.
This is normal and will stop when you have used the
iron a few times. If the smoke/smell is still present
after turning off the appliance, contact an authorised
Braun Customer Service.
Refill the water tank and press the reset button.
Turn the cap forcefully. To avoid the problem, rinse
system frequently.
Unplug the system, plug in again and press the On/
Off button. If this problem is still present, turn the
appliance off immediately and contact an authorised
Braun Customer Service.
Turn off the appliance and tighten the cleaning valve
correctly, but not overtighten it.
Note: the cleaning valve might be hot.
Turn off the appliance immediately and contact an
authorised Braun Customer Service.
Refill the water tank and press the steam button
several times for 1 minute until pump loads water
inside the system.
Turn off the appliance and wait until it has cooled
down.
11
13.10.15 15:54