Cequent Performance Products PRO Serie Guia De Inicio Rapido

ASSEMBLY INSTRUCTIONS:
1. Position the "Bike Cradles" onto top plate of carrier as shown in
Diagram 1.
Attach "Bike Cradles" to top plate with the ¼" x ½" Lg. Screws using
the Allen Wrench supplied.
2. Assemble both tubular sections together as shown in Diagram 1 and
fasten together with two 5/16" x 2-1/2" Lg. Carriage Bolts and Lock
Nuts. Tighten 5/16-18 Gr5 bolts to 17 ft-lb.
3. With the bike carrier in the upright position as shown, install the "Bail
Lock Pin" through hole in side plates and upright tube. Secure pin by
hooking the bail wire over the end of the pin.
4. Place the bike rack into your receiver hitch. Install 5/8" Hitch-pin bolt
from the passenger's side. Tighten until snug and secure with clip.
(See Diagram 1)
LOADING BIKES ONTO CARRIER:
1. Load one bike onto the first "Bike Cradle"
(closest to vehicle) so the horizontal seat tube
of the bike rests on the rubber lined "Cradle".
Adjust position of bike to find its center of
gravity. Secure bike to "Cradle" using both
Hook-N-Loop Straps on the "Cradle" as shown
in Diagram 2. Velcro straps must be fully in Diagram 2. Velcro straps must be fully
engaged and wrapped tight against bike tube.
2. Position the next bike onto "Cradle" so the
handle bars face in opposite direction and
secure using both Hook-N-Loop Straps (See
Diagram 2)
3. Repeat step two for each additional bike.
INSTRUCTIONS FOR FOLDING THE RACK:
Remove the "Bail Lock Pin" from the bike carrier.
WARNING: Removal of this pin will allow the bike carrier to pivot rearward or
forward. Be certain to hold the bike carrier securely when removing the
locking pin to prevent the bike carrier from falling suddenly, causing personal
injury or vehicle damage.
To remove the "Bail Lock Pin" simply deflect the bail wire away from the small end
of the pin and pull the pin free of the carrier.
NOTE: Do not drop or let the support tube fall freely. Make sure that your hands
and fingers are clear of the hinging area during this operation.
DO NOT attempt to move the vehicle unless the Bike Carrier is in the
upright position and securely locked.
The series of slots in the Top Plate have been provided to allow use of a
cable and padlock to protect bikes from theft. (sold separately)
Cequent Performance Products
47912 Halyard Drive, Suite 100
Plymouth, MI 48170
Technical Service: (888) 521-0510
ITEM:
DESCRIPTION:
Clip
Bail Lock Pin
63124
FOUR PLACE BIKE CARRIER,
FOLDING, 2" MOUNT
¼" x ½" Lg. Screw
(8) Places
Bike Cradle
Top Plate
5/8" Hitch-pin bolt
Receiver
Hitch Hitch
Hook-N-Loop
Strap
Hook-N-Loop
Strap
(8) Places
5/16 x 2-1/2" Lg.
Carriage Bolt
Locknut
(2) Places
Diagram 1
Diagram 2
Printed in Taiwan
63124N 4/29/13 Rev C