Dimplex Revillusion 30" Firebox Manual Del Usuario página 10

Operation
Icon Function
Power/
A
Standby
B
Heat
C
Temp Down
D
Temp Up
Change Fahrenheit
( F) to Celsius (
0
Heat Enable
Heat Disable
10
Description
Press to activate the current standby state (On/Off).
• Standby State On
Press to turn everything Off. Press again to activate
the previous state.
• Standby State Off
Press to activate the previous state.
- If the flame effect was On, the previous heat setting
will be activated (On or Off).
- If the flame effect was Off, the previous heat setting
will be activated (High or Low).
Press again to turn everything Off.
• Heat On
Press to turn heat On using remote (indicated by 1
short beep). Displays current heater temperature
setting. Use the Temp Up/Down icon to change the
heater temperature setting.
• Heat Off
Press to turn heat Off using remote (indicated by 1
short beep).
!
NOTE: After the heater is switched off, the fan will
continue on for 60 seconds before turning off.
Press multiple times to lower the heater temperature
in 1 F (1
0
temperature; lowest temperature is 41
feature is active whenever the heat is enabled.
Press multiple time to raise the heater temperature in
1 F (1
0 0
highest temperature is 99
active whenever the heat is enabled.
Press both Temp+ (
C)
0
Hold both Heat (
2 seconds. Temperature displays on the screen.
Hold both Heat (
for 2 seconds, when temperature is adjusted "---"
displays on the screen.
C) increments. Displays current
0
C) increments. Displays current temperature;
) and Temp– (
) and Temp– (
) and Temp– (
F (5
0
F (37 C). This feature is
0 0
) on the unit.
), on the unit, for
), on the unit,
C). This
0