Stihl FS 70 Manual De Instrucciones página 23

1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Unscrew the mowing head
N
clockwise.
Fitting Mowing Head without Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
FS 70 R
STIHL FixCut 31-2
Fit the thrust plate (2).
N
Place the mowing head on the
N
thrust plate (2).
WARNING
Collar (see arrows) must engage the
mowing head's mounting hole.
Push the thrust washer (3) (convex
N
side up) over the shaft (1) until it is
seated on the base.
Block the shaft.
N
Use the combination wrench (5) to
N
screw the mounting nut (4) onto the
output shaft and it tighten down
firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Use the combination wrench to
N
loosen and unscrew the mounting
nut counterclockwise from the
output shaft.
Mounting Metal Cutting Attachment
Keep the leaflet and packaging of the
metal cutting tool in a safe place.
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only one metal cutting
attachment.
Check direction of rotation of cutting
attachment
1
The cutting edges of the grass cutting
blade (1) may point in either direction –
this cutting attachment must be turned
over regularly to reduce one-sided wear.
English
2
21