Replacing Edge Brush; Replacing Light Bulb; Using An Oreckfresh Air ® Tab; Replacing Motor Filter And Oreck Fresh Air - Oreck XL21 Serie Guia Del Usuario

18 19

Replacing Edge Brush

WARNING: Unplug cord from electrical outlet before servicing.
Turn the power head over. With baseplate facing up, remove the screw located in the center of each edge brush.
Remove both edge brushes and replace with new ones. Replace both screws and tighten.

Replacing Light Bulb

WARNING: Unplug cord from electrical outlet before servicing.
Remove lamp housing by removing two (2) screws in the top of the lamp housing. Pull burned out bulb from holder
and replace with new bulb. Replace lamp housing by replacing two screws in the top of the lamp housing.
Using an Oreck Fresh Air
Your ORECK XL21 vacuum cleaner has a special ORECK FRESH AIR
This light-colored pocket is located inside the outer cloth bag in the area where the
paper filter dust bag attaches to the intake tube. Insert tablet in pocket if desired.

Replacing Motor Filter and Oreck Fresh Air

WARNING: Unplug cord from electrical outlet before servicing.
The Motor Filter located at the back of the power head should be replaced every 2 months.
The Scent Disk should be replaced every month when changing the inner filter bag.
22 Press two locking tabs on scent cartridge cover and remove the cover.
23 Remove the cartridge holder by lifting on tab at top of holder.
24 Remove old filter or scent disk from holder. Replace filter or scent disk and reinsert holder.
23 Replace door by aligning tabs on door with slots in housing and pressing the door in place until tabs lock.
22
E N
20
® Tab
®

Scent Cartridge

24
23
G L I S H
SPECIAL
21
® tab pocket.
7
NORMAL