Oreck XL Serie Guia Del Usuario página 7

5. Many times blockage occurs
due to a full dust bag
causing dirt to back down
the air flow system. When
that happens, the blockage
will be at the top of the
system, starting in the area
where the dust bag connects
to the connector assembly.
See illustration F.
NOTE: If the above actions do not correct the problem, contact
an ORECK authorized service center or call the customer service
center. US: 1-800-989-3535
CANADA: 1-888-676-7325
IMPORTANT: On plush and new carpets, stuffing may occur
due to excessive fuzz and loose cuttings in the carpet.
Stuffing could occur for the first few cleanings until all the
loose material is removed. Due to the high efficiency of the
cleaner, many older carpets will cause stuffing when the
cleaner is first used on them.
U A F
sing resh
Your ORECK XL vacuum
cleaner has a special
FRESH AIR tab pocket.
This light-colored pocket is
located inside the vinyl
bag in the area where the
paper disposable bag
attaches to the intake
tube. Insert tablet in
pocket.
B R
ulb eplacement
WARNING: Unplug cord from
electrical outlet before servicing.
E N G
F
Connector
Deflector
Opening
A T
ir ab
®
• Remove lamp housing
by removing two (2)
screws in the the top of
the lamp housing.
• Pull burned out bulb
from holder and replace
with new bulb.
• Replace lamp housing
by replacing two screws
in the top of the lamp
housing.
L I S H
T A
o djust or
WARNING: Unplug cord from
electrical outlet before servicing.
Rotate and match
bearing assemblies
IMPORTANT: Unless
the brush is worn as
indicated above,
both bearings must
be in the new
position. When
rotating, both
bearings must be in
the old position.
Unmatched settings
will cause damage
to your machine.
7
R B
eplace rush
To determine if the brush is
worn, place a firm straight
edge across the nozzle
opening. If brush bristles
do not extend beyond baseplate, brush should be
adjusted.
Remove the baseplate by
removing 5 screws. Then,
remove the belt and brush
roll from the housing.
Rotate both bearing
assemblies at ends of
brush roll to show "old"
and replace in the holding
channels in the housing.
NOTE: The bearing
assembly setting marked
"OLD" has two bars ( l l)
on the top of the assembly.
The one marked "NEW"
has one bar ( l ). When
rotating bearings, make
sure both bearing
assembly settings are the
same and face up when
replacing the brush roll.
Reassemble the belt and
the baseplate and check
bristle height above
baseplate at each end of
brush.
If a previous adjustment
has already been made
and bristle height does not
extend above baseplate, a
new brush assembly
should be ordered.