Wheel Assembly - Speedaire 3JR85 Manual De Instrucciones De Operación

Speedaire Operating Instructions
Speedaire
Compressors
Assembly
E
HORIzONTAL TANk uNITS ONLy
N
HANDLE
G
1. Remove the handle screw from the
L
tank baseplate, if preinstalled.
I
2. Insert handle into both sides of tank
S
baseplate. Squeeze handle to fit
H
into special openings in baseplate
(See Figure 2).
Handle
Bracket
Figure 2
3. Place a short piece of wood against
end of handle and tap with a mallet
or hammer until the hole in the
handle lines up with the hole in the
baseplate.
4. Insert and tighten the handle screw
into the hole in the baseplate and
through the handle. Make sure the
screw goes through the handle.

WHEEL ASSEMBLY

The items marked with an asterisk (*)
in Figure 3 were shipped loose with the
unit. Assemble as follows:
1. Insert shoulder bolt through wheel
hub with the bolt head on the
opposite side of the protruding hub
section.
Portable Air
®
Lock
Nut *
Figure 3
Tank
Baseplate
2. For the 8 inch diameter wheels,
insert the shoulder bolt in the low-
est hole of the tank axle iron and
tightly secure with locknut.
3. For the 10 inch diameter wheels,
insert the shoulder bolt in the upper
hole in the tank axle iron and tightly
Handle
secure with the locknut. Repeat this
Screw
step on the opposite side.
When assembled, the tank must sit level
or slope slightly towards the tank drain
valve to allow tank to drain properly.
Rubber
Foot
vERTICAL TANk uNITS ONLy
HANDLE ASSEMBLY
Insert four handle screws through holes
in handle and tighten to tank baseplate
(See Figure 4).
Handle
Figure 4
Wheel *
Shoulder
Bolt
Tank
Baseplate
Handle
Screw
4
Nut *
Foot *
Wheel *
Bolt *
Shoulder Bolt *
Figure 5
FOOT ASSEMBLY
The items marked with an asterisk (*)
were shipped loose with the unit (See
Figure 5).
1. Tilt unit to allow access to front foot
and secure properly to ensure unit
does not tip over.
2. Insert bolt through foot and
bracket. The foot should be on the
lower side of bracket.
3. Tightly secure with the lock nut.
Repeat on opposite side.
WHEEL ASSEMBLY
The items marked with an asterisk (*)
were shipped loose with the unit (See
Figure 5).
1. Insert shoulder bolt through wheel
hub. The bolt hex head should be on
the opposite side of protruding hub
center.
2. Feed the shoulder bolt through
the hole on the tank axle iron and
tightly secure with the locknut.
Repeat on the opposite side.
Lock
Nut *