How To Use - VORAGO BSP-600 Guía Rápida

HOW TO USE

Before you start using the device, you must fully charge it and
connect it with a compatible phone or device.
Battery charge.
This device has a built-in rechargeable internal battery. Do
not attempt to remove the battery from the device, as it may
damage the device.
The speaker will emit an intermittent beep and red flash when
the battery is low and requires recharging.
Connect your Micro USB charging cable to the charging port of
your speaker.
Connect the other end of the USB cable to a charger.
The red indicator light turns on indicating that the device is
charging.
The red indicator light goes out when the speaker is properly
charged (approximately 1-2 hours).
BT CONNECTION
Pair your bluetooth device
Slide the ON/Off switch to ON position, and press the play
button until the blue light turns on and / or red
and blue lights flash, this indicates that the speaker is in pairing
mode. Now you can use your mobile phone to connect to the
device. Note: It is only possible to pair it with only 1 device at
a time.
To pair a device other than the originally paired, turn off the BT
of the previously paired device and search the new music player
for the BSP-600 and follow the previous instructions for use.
• Consult the user manual of your device to activate the BT
and put it in detection mode. If the device requests a password
enter 0000.
The blue led of the device will turn on. This will indicate that it is
connected and running.
• Once linked you can play music directly from your device.
• Maximum distance between devices is 10m without barriers.