Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12.3.
LED Light signals
If there are any problems during installation or operation, consult the possible causes listed below:
Number of
Flashes
1
The electromechanical lock has
detected an overcurrent in the motor.
2
electromechanical lock and actuators
3
7
The internal encoder had a counting
Electric power supply error:
8
The power supply voltage is outside
the allowed range or unstable.
10
The internal memory write process
A RESET procedure is being started
11
with several actuators that are not
compatible with one another.
LED Status
STEADY-ON
FLASHING
LED Status
STEADY-ON
Duration < 0.5
seconds
STEADY-ON
FLASHING
Type of Error
Overload error:
Communication error:
Communication between the
is interrupted.
Error in the actuators
Encoder error:
error.
Memory error:
failed.
Connection error:
Device powered correctly.
The device executed a chain re-entry stroke correctly, completing the
operation by writing to the memory, or is in motion.
Device powered correctly and at the opening stroke-end.
The number of flashes indicates the address number previously assigned to
the device during the RESET procedure.
Internal memory write process in progress.
RESET Procedure in progress.
RESET Procedure finished correctly.
The number of flashes indicates the address assigned to the device in a
configuration with several devices.
WITH RED LED
Check that there are no obstacles preventing
it from completing its stroke.
Check that it has been installed correctly.
Check the condition of the connection cables,
and repeat the RESET procedure if
necessary.
Check the error LED on the actuators.
Repeat the RESET procedure.
Check the electrical contacts at the ends of
the lock's cable and ensure that the power
supply voltage is correct.
Repeat the RESET procedure.
Check the type of actuators selected for the
system.
Repeat the RESET procedure.
WITH GREEN LED
Meaning
WITH ORANGE LED
Meaning
31
Possible Solution
Tabla de contenido
