Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Hammering only
This rotary hammer can be set to ham-
mering only mode by pressing the push
button and turning the change lever to
mark. (Fig. 12)
(1) Mount the bull point or cold chisel.
(2) Press the push button and set the
change lever to middle of
mark. (Fig. 13)
The rotation is released, turn the grip
and adjust the cold chisel to desired
position. (Fig. 14)
(3) Turn the change lever to
(Fig. 12)
Then bull point or cold chisel is locked.
7. Using depth gauge (Fig. 15)
(1) Loosen the knob on the side handle,
and insert the depth gauge into the
mounting hole on the side handle.
(2) Adjust the depth gauge position ac-
cording to the depth of the hole and
tighten the knob bolt securely.
8. How to use the drill bit (taper shank)
and the taper shank adaptor.
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 16)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 16)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
Knob on side
handle
Fig. 15
mark and
mark.
Mounting hole
Depth gauge
Change lever
Push
button
Fig. 12
Change lever
Push
button
Fig. 13
Grip
Fig. 14
Drill bit
Taper shank
Front cap
adaptor
Fig. 16
English
Grip
13
Tabla de contenido
