Novellini Una Serie Manual De Instalación, Uso Y Mantenimiento página 36

MAINTENANCE AND CLEANING:
The bath is made of acrylic and must be cleaned using a liquid detergent and a soft cloth
or sponge. Use a good quality household liquid detergent. To prevent scale deposits,
wipe dry using a chammy leather or a soft lint-free cloth that removes stubborn
deposits without leaving traces. Limescale deposits may be removed using specific
detergent products. To restore shine to the acrylic surface polish with an ordinary wax
polish such as for car bodywork.
DO NOT USE ABRASIVE CLEANERS, ALCOHOL OR ALCOHOL-BASED PRODUCTS, ACETONE
OR OTHER SOLVENTS.
Warning: use of detergents other than those recommended may damage the bath
and/or the whirlpool equipment.
SURFACE SCRATCHES:
Small surface scratches can be removed using wet emery paper (grade 1000) and then
smoothing the surface with abrasive paste. Once the scratch has been removed, restore
surface shine using wax polish.
TROUBLESHOOTING:
In the event of a problem, perform the following checks before activating the warranty
or contacting qualified staff.
If the jet system does not start:
• If the circuit breaker has tripped, reset it and try switching on the jet system again.
• If the pump does not start when the water level is well above the nozzles.
• Check to ensure that the cut-out is turned on.
• Check if an alarm has been raised (see menu).
If the jet system does not stop:
• If the pump continues running and cannot be turned off using the usual controls, turn
it off using the circuit breaker and try again.
Do not make adjustments to the wiring or other electrical parts.
DISPOSING OF THE WHIRPOOL BATH:
For the disposal of the product or its parts, follow the local regulations on matters of
waste disposal. For Italy, Legislative Decree n. 152 of April 3, 2006 will hold, and for the
other EU countries, Directive 2008/98/EC.
PRODUCT GUARANTEE:
All products purchased by consumers, as defined in Article 3 of the Consumer Code
(Legislative Decree no. 206 of 6 September 2005 and subsequent amendments),
are covered by the legal guarantee of the seller under Article 128 and subsequent
amendments of the consumer Code. In case of lack of conformity of the product, we
invite the consumer to contact their dealer within the statutory deadline.
EC DECLARATION OF CONFORMITY:
The manufacturer Novellini S.p.a., Via Mantova, 1023 - 46030 Romanore di Borgo
Virgilio, Mantova - Italy Declares under its responsibility that the following products:
whirlpool baths mod. 500/10 500/20 500/30 are in conformity with the following
European directives: 2014/35/EU, 2014/30/EU and EU regulation 305/2011 and
subsequent amendments, with reference to harmonized standards:
EN 55014-1
EN 55014-2
EN 60335-2-60
EN 60335-1
EN 12764
EN 61000-3-2
EN 61000-3-3
EN 301 489-17 V3.2.0
EN 301 489-1 V2.2.0
Conforms with the European ROHS directives
And was manufactured in conformity with the European Directive 2015/863/UE, and
that the maximum concentration allowed for the following substances have been fully
complied to.
- Mercury (Hg), 0.1% max.
- Cadmium (Cd), 0.01% max.
- Lead (Pb), 0.1% max.
- Chromium VI (hexavalent chromium) (Cr(VI)), 0.1% max.
- PBB (polybrominated biphenyls), 0.1% max.
- PBDE (Polybrominated diphenyl ether), 0.1% max.
- Bis(2-ethylhexyl) phthalate (DEHP) (0,1 %) max.
- Butyl benzyl phthalate (BBP) (0,1 %) max.
- Dibutyl phthalate (DBP) (0,1 %) max.
- Diisobutyl phthalate (DIBP) (0,1 %) max.
Novellini S.p.a. Romanore di Borgo Virgilio (MN)
Whirlpool bath designed for personal hygiene.
Resistance to hair entrapment:
Cleanable
Cleaning durability
-36-
ENGLISH
07
EN 12764
Romanore di Borgo Virgilio, lì 01.01.2015
Novellini S.p.a.
Marco Novellini
Amministratore delegato
Pass
Pass
Pass