Tabla de contenido
with Sliding Latch Plate
This belt has a latchplate that
slides freely along the belt.
This belt MUST be converted to prevent
movement of the lap portion of the belt. You
must use the locking clip provided with the
infant restraint, unless your vehicle's seat belt
can be converted in another way as described in
your vehicle owner's manual.
To Install Locking Clip:
1. Tighten the buckled belt by pushing down
hard on the infant restraint and pulling
hard on the shoulder belt.
2. While pushing down on infant restraint,
pinch the two straps together behind the buckle tongue. Unbuckle
the belt without allowing it to slip.
3. Connect lap and shoulder belts with locking clip as shown
and
.
4. Rebuckle belt. Check that
lap belt does not move by
pulling and pushing hard
on infant restraint.
If belt loosens or
lengthens, repeat
procedure.
Locking clip goes here,
/
inch from the buckle
1
2
25
Locking clip
½
inch
Capítulos
Tabla de contenido
