KEB 240-ST
Battery Crimping Tool
safer at the rate for which it was designed.
u.
Do not put your fingers into the head of the tool during operating. Your fingers
could be pinched very severely.
4. Service
Have your Battery Crimping Tool serviced by a qualified service technician using
only identical replacement parts. This will ensure that the safety of the Battery
Crimping Tool Kit is maintained.
SPECIFIC SAFETY RULES
1.
Maintain labels and nameplates on the tool which carry important safety information.
If unreadable or missing, contact the agent to replace.
2.
This product is not a toy, keep it out of reach of children.
3.
Do not put your fingers into the head of the tool during operating. Your fingers could
be pinched very severely.
4.
Make sure the head was locked firmly during operation.
5.
Do not use the tool without dies
6.
Do not crimp on live cables or conductors
7.
Do only crimp cooper or Al conducting material
8.
Do not knock any parts of the tool, otherwise it will cause injury.
9.
Do not operate at will, it will damage the MCU and electric system
10. The design of the limit screw on the head is for preventing the head from dropping or
popping.
11. Make sure the head was locked firmly during operation.
12. Do not use this tool for continuous use. After 30 to 40 cycles, allow the tool to cool for
15 minutes.
13. Do not secure this tool in a vise. This tool is designed for hand-held operation.
14. The built-in safety valve goes through strict pressure test before marketing; please do
not adjust the pressure by unprofessional person. If the pressure is not enough please
return the tools back to the service center. The tool only can be reused after checking
Battery Crimping Tool
and testing by trained person.
15.
The warnings, precautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator
UNDERSTAND YOUR TOOL
BZ-6B is a tool for crimping Cu lugs with cables from 10-240 mm
actuated by motor and controlled by MCU. With a high pressure hydraulic system, LED
light, LCD , error warning alarm, pressure showing..etc function, it is a perfect tool to be
used in electrical construction site.
1. Specification
Max. crimping force:
Crimping range:
Stroke:
Crimp/Charge
Time/crimp:
Hydraulic oil:
Capacity:
Ambient temperature
Voltage:
Charging voltage:
Charging time:
Accessories:
Battery:
.
2
. It is powered by Li-ion,
60KN
2
CU 10-240mm
35mm
2
250 times(Cu150mm
)
3-6s( depend on the size of cable)
Shell Tellus T15#
115ml
-10-40℃
DC 18V,3Ah
AC 100V~240V ;50~60Hz
Approx.2 hours
2 pcs
www.grupotemper.com