Philips AQ5150 / 05P Instrucciones De Manejo página 6

Radio
RADIO RECEPTION
• Set the TAPE/RADIO selector to RADIO.
• Adjust the sound with the controls VOLUME
and TONE.
– You may connect stereo headphones with
3.5 mm plug to socket p. The loudspeakers
are then muted.
• Select the wave band using BAND selector.
• Tune to a radio station using TUNING knob.
(SW and LW not on all versions).
– For FM, pull out the telescopic aerial. To
improve FM-reception, incline and turn the
aerial. Reduce its length if the FM-signal is
too strong (very close to a transmitter).
– For AM/MW and LW (Medium and Long
Wave), the set is provided with a built-in
aerial, so there is no need to use the
telescopic aerial. The aerial can be directed
by turning the whole set.
– For Short Wave (SW), the telescopic aerial
must be pulled out and placed in the vertical
position. To improve SW-reception, vary the
length of the aerial.
• When FM STEREO 6 lights up, you are
receiving a FM-stereo station. If the FM-
stereo signal gets weak, FM STEREO 6
goes out and you will hear (and record) the
FM programme in mono.
• The set is switched off if the TAPE/RADIO
selector is in position TAPE and the recorder
buttons are released.
CASSETTE RECORDER
Copyright
Recording is permissible insofar as copyright
or other rights of third parties are not infringed.
Fast winding and rewinding
Press fast forward wind F.FWD 5 or
REWIND 6 button. To stop, press STOP 9.
Safeguarding a cassette against erasure
Keep the cassette side to be
safeguarded in front of you and
break out the left tab.
Now, recording on this side is no
longer possible.
6
AQ 5150/00. page 6
Cassette
RECORDING
• Press EJECT 9 to open the cassette holder.
• Insert the cassette.
• For recording you must use a
NORMAL cassette (IEC
which the tabs are not removed.
– At the very beginning of the
tape, no recording will take place during the
first 7 seconds when the leader tape passes
the recorder heads.
• When monitoring during recording, adjust
the sound with the controls VOLUME and
TONE. These controls do not affect the
recording.
Recording from the radio
• Set the TAPE/RADIO selector to RADIO.
• If during the recording of a AM/MW or LW
station, a whistling sound is
heard, this sound can be
suppressed by setting the BEAT
CUT switch to another position.
Microphone recording
• Set the TAPE/RADIO selector to TAPE.
• Set the VOLUME control to zero (during
microphone recordings, monitoring is not
possible).
Starting and stopping the recording
• To start recording, press RECORD 0; in
doing so, PLAY ( is pressed too.
• For brief interruptions, press PAUSE ;.
Press again to restart recording.
• To stop, press STOP 9. On pressing again,
the cassette holder will open (EJECT).
– When the end of the tape is reached, the
recorder buttons are released.
• The set is switched off if TAPE/RADIO
selector is in position TAPE and the recorder
buttons are released.
CASSETTE PLAYBACK
• Set the TAPE/RADIO selector to TAPE.
• Press EJECT 9 and insert a cassette.
– For playback, any cassette type can be
1
inserted.
• To start playback, press PLAY 1.
• Adjust the sound with the controls VOLUME
and TONE.
– You may connect stereo headphones with
3.5 mm plug to socket p. The loudspeakers
are then muted.
• To stop, press STOP 9. The set is then
switched off. On pressing again, the
cassette holder will open (EJECT).
When the end of the tape is reached, the
recorder buttons are released.
I) on
BEAT CUT
1 2