Tabla de contenido
Idiomas disponibles
Idiomas disponibles
oPeRAtING INStRuctIoNS
INStAllING ANd ReMovING tHe BAtteRy PAck fRoM tHe tool
cAutIoN:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
to INStAll BAtteRy PAck:
audible click is heard as shown in figure B. Ensure battery pack is fully seated and fully
latched into position.
to ReMove BAtteRy PAck:
in figure c and pull battery pack out of tool.
vARIABle SPeed tRIGGeR SWItcH- fIGuRe d
To turn the tool on, squeeze the trigger switch (1). To turn the tool off, release the
trigger switch. Your tool is equipped with a brake. The chuck will stop as soon as the
trigger switch is fully released. The variable speed switch enables you to select the
best speed for a particular application. The more you squeeze the trigger, the faster the
tool will operate. Use lower speeds for starting holes without a center punch, drilling in
metals or plastics, or driving screws. For maximum tool life, use variable speed only for
starting holes or fasteners.
Note: Continuous use in variable speed range is not recommended. It may damage
the switch and should be avoided.
foRWARd/ReveRSe coNtRol ButtoN- fIGuRe d
A forward/reverse control button (2) determines the rotational direction of the tool and
also serves as a lock off button. To select forward rotation, release the trigger switch
and depress the forward/reverse control button on the right side of the tool. To select
reverse, depress the forward/reverse control button on the left side of the tool. The
center position of the control button locks the tool in the OFF position. When changing
the position of the control button, be sure the trigger is released.
Note: The first time the tool is run after changing the direction of rotation, you may
hear a click on start up. This and the impacting noise that the tool makes are normal
and do not indicate a problem.
QuIck ReleASe cHuck- fIGuRe e ANd f
Note: The chuck accepts 1/4 inch (6.35 mm) hex accessories only.
Remove battery pack before changing accessories.
to INStAll AN AcceSSoRy,
quick release chuck (4) until an audible click is heard and verify the accessory is locked
in place by tugging on it.
to ReMove AN AcceSSoRy,
the tool, remove the accessory and release the collar.
Note: The quick release chuck is spring-loaded. The accessory will be ejected when
the chuck collar is pulled forward.
led WoRk lIGHt
When impact driver is activated by pulling the trigger switch (1), the integrated
LED work light (7) will automatically illuminate the work area. Note: The work light is
for lighting the immediate work surface and is not intended to be used as a flashlight.
BIt tIP StoRAGe
A bit storage slot (8) is built into the top of the tool.
Insert battery pack (5) firmly into tool until an
Depress the battery release button (6) as shown
firmly insert the accessory completely into the
pull the chuck collar (3) away from the front of
9
Tabla de contenido
