Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TOOLS OF THE TRADE
Listed next are the majority of the tools required to perform an installation. Having the proper
tools will make the installation that much easier. Some of these tools are necessities; some will
just make the job easier.
Allen Wrenches (2mm, 3mm and 4mm)
●
Electric drill with assorted drill bits
●
Heat shrink tubing
●
Phillips and flat blade screw drivers
●
Pliers (standard and needle nose)
●
RTA (real time analyzer)
●
Soldering iron and solder
●
Utility knife
●
Wire brush or sandpaper for chassis grounding
●
Reference CD with 1 kHz Sine Wave at 0dB level (all bits high)
●
END PANEL LAYOUTS
Input Plate
Figure 1
Figura 1
Abbildung 1
Figure 2
Figura 2
Abbildung 2
Power LED - When lit indicates that the amplifier is on.
1.
2.
High Level Input - Connect speaker output from factory radio to amplifier, will auto
sense signal from radio and turn amplifier on when needed, turn off after 1 minute
© 2012 MD Audio Engineering —all rights reserved
CO3002
1
2
3
CO6002
1
2
3
DMM or VOM
●
Grommets
●
Marking pen
●
Nylon tie straps
●
Wire crimper
●
Wire cutters
●
Wire strippers
●
4
5
6
7
4
5
6
7
8
9
8
9
3
Tabla de contenido
Solución de problemas
