Tabla de contenido
PROBLEM OR CONCERN
No water coming out of Wand
(contd)
Trigger will not move
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit will not stop when trigger
is released
POSSIBLE CAUSE
Detergent Suction Assembly (the
part which the High Pressure
Hose connects to) is defective
Gun/Hose Assembly is defective Attach the Gun/Hose to the front of the unit
Gun Safety Lock in engaged
Unit is not turned on
Loose or disconnected Plug
Defective GFCI Plug
Extension Cord length or gauge
incorrect
Gun trigger not operating
properly
Defective Gun
Tripped Pressure washer Thermal
Switch
Defective ON/OFF Switch
Screen filter is clogged
Garden Hose is kinked or leaking
water
SOLUTION
Remove the Gun and Hose assembly from the
front of the unit. Aim water stream away from
electric source. Turn the faucet on. Water should
start to come out of the front of the unit. If no
water comes out, the Detergent Suction Assembly
will have to be replaced. Contact us at:
or order a replacement directly online at:
www.huskypowerwasher.com.
with no wand attached to the Gun. Squeeze the
trigger of the gun to ensure that water comes
out of the front of the Gun at a rate equal to the
Garden Hose. If no water comes out of the Gun
it will have to be replaced. Contact us at:
or order a replacement directly online at:
www.huskypowerwasher.com.
Release Safety Lock as instructed in Manual.
Press ON/OFF Switch into ON position.
Reconnect Plug.
If the Plug does not work it will need to be repla-
ced. Contact us at:
or order a replacement directly online at:
www.huskypowerwasher.com.
Use proper Extension Cord as instructed in section
.0.
Contact us at:
or order a replacement directly online at:
www.huskypowerwasher.com.
Remove the Gun and Hose assembly from the front
of the unit. Aim water stream away from electric
source and switch the unit into the ON position.
If the unit starts and water comes out of the front,
the Gun may need to be replaced. Contact us at:
or order a replacement directly online at:
www.huskypowerwasher.com.
Allow to cool and restart unit.
Contact us at:
or order a replacement directly online at:
www.huskypowerwasher.com.
Clean the Screen filter as instructed in the
section ..
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.
Tabla de contenido
Solución de problemas
