FrostEmily PRISMA 400 TBV-PF Instalación Y Uso página 7

3 . Ensure that there is no danger of explosion (AD) in the room. . The connecting cable to the appliance
is H05 VVF, designed for internal use. . Connect the plug (do not use three-way adapters and reduction
N.B.
adapters). If during transport or storage the appliance has been placed by mistake in a horizontal
position or has been turned upside down, leave for at least three hours in the correct position before
switching on the power supply (see figure 4).
7. CONTROLS
The controls of the appliance are located at the front inside a protected panel.
1. Refrigeration switch:
to switch on the refrigeration system.
3. Rotation switch:
inside the appliance.
is closed, and will stop when the door is opened or when it meets even the slightest obstacle (for safety
4. Thermometer:
reasons).
temperature in the appliance.
positive temperature (higher than 0°C). To adjust the temperature:
display the current temperature setting, which can then be changed by using button
8 "DOWN"
button to reduce (see figure 5).
8. CHECKING CORRECT OPERATION
Check that: 1.
The plug is connected. . The refrigeration unit switch is switched on (green light on).
3 . The thermometer shows the desired temperature for the goods to be stored. . The appliance is not
exposed to direct sunlight or to high-powered lamps. . The room temperature does not exceed that in
which the appliance is designed to work normally, i.e. + 25°C, 60% r.h. (climatic class 3).
appliance must be correctly filled, without overloading the shelves and with sufficient space for correct
cold air circulation.
9. INTERNAL CLEANING (EVERY 15 DAYS)
1. Switch off the appliance.
accessories with a sponge dipped in water with a little sodium bicarbonate. Dry with care.
10. REPLACING THE INTERNAL LIGHTS
1.
Switch off the appliance. . Undo the screws which hold the top lamp socket in place. . Detach the
fluorescent tube with its protective cover from the top lamp socket. . Take the tube out of the bottom
5
lamp socket. . Remove the protective cover. . Replace the fluorescent tube. . Reassemble by following
the above instructions in reverse order (see figure 6).
11. REPLACING THE DOOR'S MAGNETIC GASKET
1. 2.
Open the door. Take hold of the magnetic gasket and pull it out of the frame. . Insert the new
gasket and press it firmly down all around (see figure 7).
Operator's guide
5
to start shelf rotation; the shelves will only rotate when the door
to display the temperature inside the appliance.
5. Fan switch: must be turned to ii when the refrigerator is working at a
2
5
2 . Open the door and remove the refrigerated goods.
2
6
7
4
2. Light switch:
to switch on the light
Thermostat:
a) 6 "SET"
Press button
7 "UP"
4
N.B.:
3. Wipe the sides and
3
4
7
3
I
UK
D
E
to adjust the
F
once to
NL
to increase or
P
S
DK
the
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO