Battery Installation & Safety - Kapro PROLASER 875 GREEN Manual Del Usuario

BATTERY INSTALLATION & SAFETY
This tool operated by designated Li – Polymer battery pack.
Installation of the Li - Polymer Battery pack
1. Make sure that the closing latch on the battery pack is in
most right position.
2. Insert the Li – Polymer battery pack with the contact
terminals on the bottom towards the 2 small pins in the
battery compartment.
3. Push the battery pack in and slide the closing latch to the
most left position.
4. Use a standard 3.5 – 5.3 Volt charger (1Amp. - 2mp.), with
micro USB connector to charge the lithium – polymer battery
pack. Charge indicator on the battery pack will blink during
the charging.
5. The rechargeable battery pack can be charged outside or
inside of the laser battery compartment. You can work with
the laser level while charging.
6. Charge indicator will show the charge of the battery pack.
Recharge the battery pack if the indicator shows 25% of
charge. In case of long period of time without use, recharge
the Li-Polymer battery pack every 3 months to 75% of charge
or more.
7