Idiomas disponibles
Idiomas disponibles
The positioning and electrical and gas installation should always be carried out by an AUTHORISED
TECHNICIAN, observing the standards of each country.
•
It is advisable to install an extraction hood for the optimum operation of the appliance.
•
Place the appliance in a well-ventilated place.
•
Level and adjust the height of the appliance.(Fig. 1)
An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a minimum of 3
mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not
fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in
diagram no. 2.
VERY IMPORTANT: Fasten the electric supply cable tightly to the stuffing box.
When several appliances are installed in series, they should be earthed to each other using the point
assigned for this purpose, located in the appliance's base, at the back.
After installing the appliance, and before filling the vat with oil, it is necessary to fill it with soapy water,
which should be left to boil for a few minutes.
Next, empty the vat and rinse it as many times as necessary, to eliminate the remains of soap.
Usage
IMPORTANT: Never start up the appliance without having previously filled the vat, otherwise overheating
would seriously damage the machine.
The oil should be filtered regularly, in order to preserve it better.
Replace the oil when it reaches the MINIMUM level (Fig. 2).
It is recommended to insert the loaded basket in the oil slowly so that the oil froth resulting from frying
does not boil over the upper part of the vat.
1.-INSTALATION
Positioning and levelling
Electrical connection
2.-USE
Turning the appliance on
15
