Glacier bay 1000839366 Guía De Uso página 7

Installation (continued)
TESTING THE FIT OF THE SINK
- Place the sink (A) underneath the cut-out in the counter to test
its fit. Ensure that the reveal is equal on all sides when viewed
from above . There should be at least 3/8 in . (9 .5 mm) of deck
revealed on all sides to accomodate the cutting board (D) . Make
adjustments to the cut-out if necessary .
- When you are satisfied with the location of the sink (A), mark the
location of the edge of the counter cut-out on top of the sink and
all around the sink flange underneath the counter.
- Set the sink aside and proceed with the rest of the installation .
A
3/8 in.
(9.5 mm)
Counter
Cutting Board
DRILLING THE HOLES FOR THE
UNDERMOUNT CLIPS
- On the underside of the counter, mark the location of the
ten holes for the undermount clips (H) . These holes should
be equally spaced around the sink flange outline as shown
below. They should be set back from the sink flange outline
by 5/8 in (15 .8mm) .
- Using an electric drill with a 3/8 in . (10 mm) drill bit, drill
each hole so that it is 3/8 in . (10 mm) in diameter and 5/8 in .
(15 .8 mm) deep . Use a drill bit depth stop to ensure you do
not drill through the counter top .
5/8 in
15.8 mm
Counter
Faucet Hole
7
CAUTION: Always wear safety goggles and gloves when
using power tools to prevent personal injury .
Undermount Clip Hole locations
(Underside of Counter)
HOMEDEPOT .COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance .
Sink Flange Outline